One, working principle:
The main component of the equipment is the spiral of the bottom diameter of the material is gradually increasing, and the pitch is gradually reduced. When the material is pushed by the screw, the volume of the spiral cavity is reduced.
The direction of rotation of the main shaft of the spindle is seen in the direction of the slag chute from the feed hopper, in order to clockwise direction.
The material is added into the hopper, and the pressing of the material is pressed under the push of the screw, and the waste is discharged through the annular gap formed between the conical part of the screw and the adjusting pressure. Used for clockwise (from the equipment of the slag groove into the hopper side to see the rotation of the hand wheel shaft when the bearing seat, adjust the pressure head to the left, the gap is reduced, and vice versa. Change the size of the voids, adjust the slag resistance. Can change the slag rate, but if the gap is too small, in a strong squeeze, some of the slag particles and juice together through the filter was squeezed out, although the juice increased, but the quality of the relative decline in the size of the gap should be determined by the user specific process requirements.
Two, installation operation and maintenance
1, the machine must be installed horizontally, and fixed with anchor bolts.
2, operation:
When the device starts up, the pressure head should be adjusted to reach the maximum, then the gap is gradually reduced, and the position of the brake is fixed with the brake.
3, the feed must be uniform, no hard foreign bodies into the hopper, so as not to damage the screen.
4, maintenance:
After each shift work must be washed with water and brush. If the essence of the fiber quality of the juice is more, must be treated as the production of the case, the increase in a washing net, after crushing with hot water washing all the machines
